Electrical​/Electronics & Semiconductors Engineer_L

Job Title

Design and install electrical subsystems on small robots and other ground-based vehicles. Coordinate design and installations under the direction of senior engineers. Design electrical topology of Drive By Wire systems, including harness design and pin mapping. Build and test wiring harnesses; troubleshoot, repair, and modify electrical wiring. Analyze serial bus (i.e., CAN) electrical signals and data for troubleshooting. Program electronic modules and components.

Build, test, troubleshoot, repair, and modify developmental electronic components and systems. Work under the direction of senior engineering staff with minimal supervision. Demonstrate leadership by operating independently and proactively.

Design electrical system diagrams, including harnesses. Work closely with other engineers on routing harnesses and placing electronic modules. Program embedded modules using C and logical visual programming languages. Assemble and test experimental wiring harnesses, electronic modules, and other components. Troubleshoot electrical prototypes to correct functional deviations. Diagnose and perform preventive and corrective actions for electrical or mechanical malfunctions. Work from wiring diagrams, layout drawings, and engineering specifications for system modifications or expansions.

Adjust and replace defective or improperly functioning circuitry and electronics components. Test electronics units using standard test equipment and analyze results. Plan, complete, and record periodic electrical testing and recommend modifications. Perform preventative maintenance and calibration of equipment and systems. Maintain working knowledge of state-of-the-art tools or software through continuous learning.

Bachelor's degree in Electrical/Electronic engineering or related field (or equivalent combination of education and experience). Minimum 5 years' experience with electronics systems integration and troubleshooting. Proficiency in test equipment usage including Oscilloscope, multi-meter, protocol analyzers, and power supplies. Experience with CAD/Circuit design. Knowledgeable in building and testing harnesses according to IPC/WHMA-A-620. Familiarity with electronics wire routings. Experience with basic office software including word processing, spreadsheets, and calendaring.

Basic mechanical assembly knowledge. Experience using hand tools is preferred.

Must occasionally lift and/or move up to 50 pounds. Regularly required to sit and use hands, and regularly required to walk, stand, and bend. Must be able to work on and around heavy equipment, including climbing on and off large machines.