Drilling Operator - Third Shift Overnights

Job Title

3rd Shift runs from 10:30 p.m.

- 7:00 a.m., Monday
- Friday. Overtime will often be available during the week. Training may take place on 1st or 2nd shift for the first 4 - 6 weeks.

Actively involved in all duties for procedures related to operate machines to drill and/or rout panel boards.

• Position panels on machine table, flush and aligned with tooling holes, start operation and remove boards at the end of the cycle.
• Check processed parts against template.
• Check tool sizes, remove and replace reset tools in magazine. Replace broken tools as required.
• Obtain and put away drills, mark drills that need to be re-sharpened.
• Notify supervisor of unusual equipment or operating difficulties.

A high school diploma is required.

Standing for long periods of time is required. Exertion of up to 50 lbs. of force occasionally may be required. Good manual dexterity for the use of common office equipment such as computer terminals, calculator, copiers, and FAX machines. Use of small drill bits; dexterity required.

This position is in a manufacturing setting with exposure to noise, dirt and chemicals.

Training may take place on one of three shifts for the first 4 - 6 weeks based on performance:

1st shift training: 7:00 a.m.

- 3:30 p.m.

Mid shift training: 11:00 a.m.

- 7:30 p.m.

2nd shift training: 3:15 p.m.

- 11:45 p.m.

Permanent schedule would be 10:30 p.m.

- 7:00 a.m., Monday
- Friday with some overtime available during the week.