Location:
Windsor, Ontario, with travel to Huron, Michigan
Duration: 3–4 weeks, with potential for extension
Rate: $65–$80 per hour
We are seeking an intermediate-level FANUC Robot Programmer to support the installation and commissioning of two automated plastic welding machines used in gas and diesel fuel tank production. Each machine contains approximately 10 FANUC robots.
Based at the Windsor plant initially, the successful candidate will receive training before travelling to Huron, Michigan, to support the installation and fine-tuning of the equipment.
Key Responsibilities- Retouch FANUC robot points and adjust position registers following machine reinstallation.
- Fine-tune robot positions for inline pickups, load trays, and final tank placement.
- Modify HMI offsets, string variables, and job numbers to accommodate different tank variants.
- Troubleshoot robot positioning issues and support commissioning activities.
- Hands-on experience with robot points, position registers, offsets, and variables.
- Ability to work independently in an industrial automation environment.
- PLC programming experience alone is not sufficient; PLC programming is not required for this role.
Canadian candidates able to travel to the United States are preferred. Accommodation and travel arrangements are to be confirmed. The initial assignment is expected to last three to four weeks, with potential for further work at the Windsor plant.
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).