MIG Welder

Starting pay rate dependent on skill level which is determined by weld test.

Full Time.

Benefits: Medical, Vision, Dental, 401K, Life Insurance.

• Other duties may be assigned.
• Build Subassemblies for compactors and/or balers utilizing existing fixtures.
• Weld to acceptable quality expectations on all weld positions (flat, down, over).
• Assemble and weld sides, floors, and dog boxes on compactors.
• Assemble and weld sides, floors, tops, doors, and wire gates on balers.
• Ability to meet production standards.
• Maintain good attendance record and be able to work overtime as needed.
• Maintain good safety record.
• Maintain positive attitude.
• Positions parts together by means of clamps, tack welds, and along layout marks.
• Part positioning may occur at floor, table, shoulder, and above shoulder levels.

• Experienced MIG welder.
• Requires supervision.
• Can read basic blueprints or drawings.
• Ability to use tape measure.

• High school diploma or general education degree (GED); or relative experience and/or training for job classification.

• Ability to read and comprehend simple instructions, short correspondence, and memos.
• Ability to write simple correspondence.
• Ability to effectively present information in one‑on‑one and small group situations to other employees of the organization.

• Depending on job classification, may require basic math and/or tape measure reading.
• Depending on job classification, may require ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.

• Ability to apply common sense understanding to carry out detailed but uninvolved written or oral instructions.
• Ability to deal with problems involving a few variables in standardized situations.

The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

While performing the duties of this job, the employee is regularly required to:

• Stand, walk, and talk, or hear.
• Reach with hands and arms.
• Climb or balance, and stoop, kneel, crouch, or crawl.
• Use hands to finger, handle, or feel.
• Regularly lift and/or move up to 10 pounds, frequently lift and/or move up to 50 pounds, and occasionally lift and/or move up to 100 pounds.

While performing the duties of this job, the employee is frequently exposed to moving mechanical parts and fumes or airborne particles. The noise level in the work environment is usually moderate.