G4G Structural Welder

3G4G Structural Welder

Location: 17102 LA-330 Abbeville, LA 70510

Employment Type: Full-time

The 3G4G Structural Welder is a single-process, shop-based role. The Structural Welder - 3G/4G is expected to produce fillet, groove, and plug welds on structural steel assemblies using FCAW exclusively - both self-shielded (FCAW-S) and gas-shielded (FCAW-G) as specified by the applicable WPS. The 3G and 4G position qualifications are the benchmark: vertical and overhead welding are the most physically demanding and technically exacting positions in structural fabrication, and a welder who can produce consistent, code-quality welds in these positions with FCAW is a skilled-trade professional who directly drives production quality and shop throughput.

Acadian Contractors, Inc. maintains a continuing policy of non-discrimination in employment. It is our policy to provide equal opportunity to protected veterans in all phases of the employment process and in compliance with applicable federal, state, and local laws and regulations. This policy of non-discrimination shall include, but not be limited to, the following employment decisions and practices: hiring; promotions; demotions or transfers;

layoffs; recalls; terminations; rates of pay or other forms of compensation; selection for training, including apprenticeship; and recruitment or recruitment advertising. All employment decisions are based only on valid job requirements.

• Produce groove welds in 3G (vertical) and 4G (overhead) positions on structural steel plate and built-up members using FCAW per applicable WPS - consistently achieving full fusion, proper reinforcement, and acceptable bead geometry on every pass
• Maintain machine setup discipline - verify voltage, amperage, wire feed speed, and shielding gas flow rate against the WPS before beginning any weld joint; adjust within WPS essential variables only and report required deviations to the Lead Welder
• Produce fillet welds in all positions (1F, 2F, 3F, 4F) on structural connections, gussets, base plates, stiffeners, and clip angles as dimensioned on fabrication drawings and weld maps
• Control interpass temperature using contact thermometers or temperature-indicating sticks - do not begin subsequent passes until temperature is within WPS-specified interpass range
• Perform thorough weld prep before striking arc - verify joint geometry, root gap, bevel angle, and fitment against the WPS and drawing; reject and return improperly fitted components to the fitter before welding begins
• Perform thorough inter-pass slag removal using chipping hammers and wire brushes between every FCAW pass - inspect each pass visually before depositing the next; do not bury slag, porosity, or visible fusion defects under subsequent passes
• Apply preheat as required by AWS D1.1 Table 3.2 or WPS for the applicable base metal grade (A36, A572, A992, A500, etc.) and thickness - verify preheat temperature across the specified zone before arc initiation
• Perform post-weld visual inspection (VT) of completed welds against AWS D1.1 visual acceptance criteria - verify weld size, profile, reinforcement, undercut, overlap, and surface crack condition before calling for QC sign-off
• Read and interpret fabrication drawings, weld symbols (per AWS A2.4), weld maps, and cut sheets - identify weld joint type, size, length, and position requirements without requiring repeated explanation from the foreman
• Respond promptly and professionally to NDE findings - when a weld is rejected by UT or MT, review the reject report with the QC Inspector, perform excavation and repair within the WPS and repair procedure, and present the repair for re-inspection
• Stage and position work pieces correctly for welding using fixtures, jigs, clamps, and positioning equipment - ensure structural members are supported and secured to prevent movement during welding that would introduce distortion or misalignment
• Maintain a clean, organized welding station - protect welding equipment and leads from damage, return consumables to proper storage, and keep the booth area free of debris, spatter buildup, and slip/trip hazards
• Operate welding equipment,…