Maintenance Service Specialist; Shift TBD

Maintenance Service Specialist (Shift TBD)

Job Category: Facilities/Maintenance
Requisition Number: MAINT
002773

Location: Micro Port Orthopedics, 5677 Airline Rd, Arlington, TN 38002, USA

Shift Details: 1st shift 7:00 am–3:30 pm (Mon‑Fri); 2nd shift 3:00 pm–11:30 pm (Mon‑Fri); 3rd shift 11:00 pm–7:30 am (Mon‑Fri);
Shift Premium 5% for 2nd shift, 6% for 3rd shift.

As Maintenance Service Specialist, you will perform maintenance on both CNC and manual equipment and assist outside OEM technicians in repair and setup of new equipment.

• Perform troubleshooting and evaluate mechanical, hydraulic, and electrical units and controls to determine source of malfunction.
• Use blueprints, machine specifications, and schematic drawings to determine repair procedures.
• Remove and replace defective units, controls, or components; test and repair components such as PC boards, power supplies, and control stations with oscilloscopes, VOMs, and logic probes.
• Adjust sensitive electrical, thermal, and timing devices to machine specifications.
• Start repaired and/or new equipment to verify readiness for operation.
• Comply with all health, safety, and environmental policies and procedures.
• Hold a valid current driver’s license to travel to local vendors for repair parts and supplies.
• Perform preventive maintenance on all equipment.
• Monitor all daily Industrial Wastewater Discharge Points (pH pits and outfalls).

Please note this job description is not designed to cover or contain a comprehensive listing of activities, duties or responsibilities that are required of the employee for this job. Duties, responsibilities, and activities may change at any time with or without notice.

• Ability to replace ball screws, servo motors, solenoid valves, and control boards.
• Willingness to obtain aerial and forklift licenses within the first year after starting.
• Proficiency in soldering, welding, and fabricating.
• Experience using VOM, clamp‑on ammeter, hammers, pliers, and wrenches.

Driver’s license required.
Current forklift and aerial license required or willingness to obtain forklift and aerial license within the first six months of hire.

Required: High School Diploma or GED.
Preferred: Associate’s Degree in Industrial Maintenance Technology or related technical field strongly preferred.

• Minimum 1 year as a Machine Maintenance Technician involving electrical, hydraulic, and pneumatic systems, including repair of CNC equipment, or minimum one year as a machinist.
• Minimum 3 years as a Machine Maintenance Technician with similar responsibilities.
• Minimum 5 years for a senior level position.

Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities. This employer is required to notify all applicants of their rights pursuant to federal employment laws. For further information, please review the Know Your Rights notice from the Department of Labor.